1. Home
  2. Accessories

Wonderful DIY Jewelry Hand Holder

VIEW IN GALLERYjewelry-hand-holder F
VIEW IN GALLERYjewelry-hand-holder-1
VIEW IN GALLERYjewelry-hand-holder2
VIEW IN GALLERYjewelry-hand-holder-3
VIEW IN GALLERYjewelry-hand-holder4VIEW IN GALLERYjewelry-hand-holder
This is a creative and clever storage idea for your jewelry .It will help you to keep the jewelry in order, so you can take inventory of most of your necklaces, rings,and earrings at a glance to decide which ones to wear. Following the below directions, you will make one easily .

You will need:

– 1 kg plaster of Paris;
– a pair of resistant rubber gloves;
– timber of 20 x 30 cm;
– a glass;
– pencil.

Directions:
Use the glass and the pencil to mark a circle on the timber board, then cut off the circled part using an electric drill and a cutting machine. Finish the edge of the hole with sandpaper and place the glove in the hole fixing it with staples (use a stapling device). Now, prepare a mix of water and plaster of Paris. Measure how much water you need by using the other glove. Put the water in a bowl and sprinkle plaster over it. Do not stir the mixture yet. Let it set for an additional minute or two. Stir the mixture with the spoon or spatula briefly, with slow side-to-side motions. The composition should be neither thin nor thick. Pour the mixture into the glove and let it harden for 48 hours. Finally, you can break the glove to remove it more easily. Enjoy your jewelry hand holder!
Photo courtesy:   Bepunt

MUST DO DIYs